Product Selector

Alishield F6 Roller Shutters

  • Alishield F6


The Alushield F6 offers a flat appearance to the roller shutter as its uses a heavy duty 89mm flat extruded aluminium sections. This allows the F6 to be ideal for larger openings where a refined finish is required.

Common use

The F6 can be used on retail outlets, shopping malls, outlets, department stores as shop fronts when vision through the security shutters is not required.

Alishield F3

Maximum Width:



Normally 89mm x 1.5mm


10kg per square metre


Mill finish standard, polyester powder coat colours and anodised finishes areavailable

View Shutter Box Specifications


0.91mm bright spangle galvanised pressed steel coil casing available in various different designs to suit individual circumstances

Box sizes

Overall height (top of box)
Up to 1500mm box size 254mm
Up to 2500mm box size 305mm
Up to 3500mm box size 355mm


Galvanised steel as standard but polyester powder coat colours are available at an additional cost.

View Guide Rail Specifications


Standard guide rails are 75mm x 38mm x 3mm Aluminium with brush seal others available on request.
Electric shutters require a 50mm x 50mm steel box section (both sides) used to allow for motor unit and safety brake. A 76mm x 50mm box section will be used for shutters over 160kg in weight (4800mm x 3200mm approximately).


Mill finish as standard, polyester powder coat colours and anodised finishes are available.

View Operational Specifications

Spring Loaded

A counter balanced spring ensures controlled raising and lowering with a key lock in-built at the bottom of the shutter for security.

Single Phase Electric

A tubular motor within the barrel assembly with limit switches and thermal cut out to prevent overheating.
Draw 240 volts and 0.5 - 2.5 amps dependant upon the shutter size
Provision of a 13 amp fused spur is required for installation


A manual override is included to operate the shutter in the event of a power failure. This is usually only Operable from only one side.

Product specification may change and it is advisable to consult with HAG technical advisors before specifying or ordering.
HAG operates a policy of continuous improvement.

Our Products & Services