Product Selector

Armourguard® C2 Roller Shutters

  • Armourguard C2

Description

The C2 model provides the high quality security level of the Armourguard range with a superior long life coating. The 76mm curved galvanised steel section profile is covered by a HP colour coat 200 micrometer heavy duty plastisol coating on the outer face and a two coat anti corrosive primer applied to the reverse.

Common use

The Armourguard C2 can be installed on all types of industrial, retail and commercial properties as a security shutter when maximum durability is required. They are available in standard colours to coincide with the building, or to match standard British steel cladding coloured materials that may have been used on site.

Alishield F3

Maximum Width:

10000mm

Dimensions:

Normally 76mm x 0.71mm

Weight:

9.34 kg per square metre

Finish:

HP200 is British Steel's roofing and cladding steel with a 2000 micrometre(nominal thickness) high-performance plastisol coating on a galvatite hot dip zinc coated substrate to BS EN 10146. The standard reverse side coating is a specially formulated two coat protective system of corrosion resistant primer topped with a heat cured high performance polyester. It is suitable for most internal environments.

View Shutter Box Specifications

Construction

0.91mm bright spangle galvanised pressed steel coil casing available in various different designs to suit individual circumstances.

Box sizes

Overall height (top of box) Commercial Industrial
Up to 2050mm box size 254mm 355 +
Up to 2800mm box size 305mm 355 +
Up to 3500mm box size 355mm 355 +
Please note industrial shutters have different size plates/boxes
On widths exceeding box sizes may move up one size due to deflection.

Finish

Galvanised steel standard. Polyester powder coat colours are available.

View Guide Rail Specifications

Construction

Standard guide rails: 38mm x 32mm x 3mm - 100mm x 32mm x 3mm dependant on width
Electric shutters require a 50mm x 50mm steel box section (both sides) used to allow for motor unit and safety brake. A 76mm x 50mm box section will be used for shutters over 160kg in weight (5000mm x 3200mm approximately).

Finish

Galvanised steel standard. Polyester powder coat colours are available.

View Operational Specifications

Spring Loaded

A counter balanced spring ensures controlled raising and lowering with a key lock in-built at the bottom of the shutter for security.

Single Phase Electric

A tubular motor within the barrel assembly with limit switches and thermal cut out to prevent overheating.
Draw 240 volts and 0.5 - 2.5 amps dependant upon the shutter size
Provision of a 13 amp fused spur is required for installation

Three Phase Electric

Design of this model will alter for three phase operation.
Electrical requirements are dependant on usage, further details on request

Override

A manual override is included to operate the shutter in the event of a power failure. This is usually only Operable from only one side

Hand Chain Operation (Industrial)

A counter balanced helical spring controlled via hand chain and chain lock to secure.

Control

Standard security key switch or rocker switch. Other controls are available on request.

Product specification may change and it is advisable to consult with HAG technical advisors before specifying or ordering.
HAG operates a policy of continuous improvement.

Our Products & Services