Product Specification
Product Overview
Description
The Armourguard P1 security shutters are constructed from 50mm flat, galvanised 20 gauge lath with 3mm perforations. (30% Vision)
Common use
Kiosk, bars and shop fronts security shutters where vision or ventilation is required
Maximum Width
3500mm
Dimensions
Normally 50mmx 0.91mm
Weight
13kg per square metre
Finish
Galvanised bright rolled mild steel, polyester powder coat colours are available.
Shutter Box Specification
Construction
0.91mm bright spangle galvanised pressed steel coil casing available in various different designs to suit individual circumstances.
Box sizes
Overall height (top of box)
Up to 2050mm box size 254mm
Up to 2800mm box size 305mm
Up to 3500mm box size 355mm
Finish
Galvanised steel standard polyester powder coat colours are available at an additional cost.
Guide Rail Specification
Construction
Standard guide rails: 38mm x 32mm x 3mm – 67mm x 32mm x 3mm dependant on width. Electric shutters require a 50mm x 50mm steel box section (both sides) used to allow for motor unit and safety brake.
Finish
Galvanised steel standard polyester powder coat colours are available.
Operational Specification
Spring Loaded
A counter balanced spring ensures controlled raising and lowering with a key lock in-built at the bottom of the shutter for security.
Single Phase Electric
A tubular motor within the barrel assembly with limit switches and thermal cut out to prevent overheating. Draw 240 volts and 0.5 – 2.5 amps dependant upon the shutter size. Provision of a 13 amp fused spur is required for installation.
Override
A manual override is included to operate the shutter in the event of a power failure. This is usually only Operable from only one side.
Control
Standard security key switch or rocker switch. Other controls are available on request.
Product specification may change and it is advisable to consult with HAG technical advisors before specifying or ordering. HAG operates a policy of continuous improvement.
